Q. When should I check my mileage and when can I expect results?

A. It is a good idea to know your mileage before you install your Magnoflow™. Mileage is the sum of total miles driven, divided by the total fuel used in gallons. (Or use our calculator) Most people believe they are receiving better mileage before the 2000mi-stabilisation period. We suggest that you drive 2000mi of normal driving before checking for improvement.

Q. Can I install Magnoflow™ myself?

A. Yes, most people can install the Magnoflow™ themselves. All you do is attach the two Magnoflow™s around the fuel supply line, 10 centimetres apart from each other with the cable fasteners. (supplied) . The biggest challenge is often determining where the fuel supply line is. If in doubt ask your local service repairer, he will know.

Note: The fuel injection engines have two fuel lines running in parallel between the fuel tank and engine, a supply line and a return line, so  make sure you install it on the SUPPLY LINE . (fuel flow direction to the engine)

Q. How do I tell which is the fuel line direction?

A. Sometimes it is best to trace the fuel line coming back from the gas tank or coming from the fuel filter leading to the engine compartment, or ask your service repairer.

Q. Where do I place the Magnoflow™?

A. Anywhere in the engine compartment, (where permissible) leading to the carburetor or fuel injectors.
This will depend from car to car.

Q. How long does it take to install the Magnoflow™?

A. If the fuel line to the carburetor or the fuel injectors is freely accessible; installing on the fuel line will take normally less than 5 minutes.

Q. Does Magnoflow™ work on any fuel line?

A. Magnoflow™ is powerful enough to penetrate fuel lines of non-magnetic material such as rubber, plastic, stainless steel, and aluminium; these fuel lines should be used.

Q. Why should I have two pieces of the Magnoflow™ in my engine compartment?

A. Due to the fact that there is a distance of 4 inches between the two devices, the first unit has to make a pre-treatment of the fuel and the second will disperse the fuel in order to get the best possible results. This will ensure a better mix between the fuel and air particles, which leads to a better combustion.

Q.Will my Magnoflow™ affect the factory warranty on my vehicle?

A. NO, Since the Magnoflow™ is designed in a clamp-on configuration, there are no modifications made to the fuel line.

Q. How long will my Magnoflow™ last?

A. FOREVER, Your Magnoflow™ comes with a lifetime power warranty since they are made with permanent magnets, which never lose their power.

Q. Can Magnoflow™ damage my engine in anyway?

A. Absolutely Not, The Magnoflow™ is non-invasive. All it does is place a positive charge in the fuel so the molecules combust more efficiently.

Q. Is Magnoflow™ good for your car’s engine?

A. Yes, it is. Over time the Magnoflow™ will clean carbon and varnish deposits from the combustion chamber of the engine, resulting in better power and performance.

Q. Is Magnoflow™ patented?

A. Yes. The Magnoflow™ was developed through a methodical, disciplined and extensive testing program. The key elements of the Magnoflow™’s patented application of magneto hydrodynamic technology are a specific placement of each magnet within its santoprene case. This unique angle of the Magnoflow™ is a specially designed octagonal shape which causes one magnet half to act as a “transmitter” and the other half to act as a “receiver”. This combination results in a strong magnetic field, directed to the fuel flow, which easily penetrates the fuel line. Although magnetism is a basic physical principle and can not be patented, Magnoflow’s™ unique specific application of magnetic technology is patented.

Q. Is there anything I need to do after installing my Magnoflow™?

A. No, However, your Magnoflow™ was not designed as a “Band–Aid”. If your vehicle is due for or in need of a tune-up, this should be done prior to installing your Magnoflow™, also it would help to replace your air filter.

Q. Will my Magnoflow™ cause any problems with the computer in my vehicle?

A. NO, The computer is usually located inside the vehicle and with the proper installation of the Magnoflow™, there is plenty of distance between your Magnoflow™ and the computer, and therefore the computer in your car cannot be affected by the presence of a magnet.

Q. What is hydrocarbon?

A. It is the hydrogen and carbon content of the fuel.

Q. What are hydrocarbon chains /molecules?

Hydrocarbon are molecules that cluster and grow causing molecules to be trapped from air during the combustion.

Q. Why does it take up to 2000mi for gas and up to 3000mi for diesel engines to run in?

A. This allows Magnoflow™ to do its job by removing the carbon/varnish deposits. Remember it took thousands and thousands of miles to build up these deposits in your engine.

Q. How long will it take my Magnoflow™ to make a difference in my mileage?

A. Generally the driver of the vehicle will notice a change in the performance ALMOST IMMEDIATELY. The mileage sometimes may fluctuate during the stabilization period (approximately 2000mi for gas engines and 3000mi for diesel engines). It also depends on the size and type of engine, mode of driving, whether city or highway, and weather conditions. Fuel savings of up to 20% have been reported.

Q. After installing the Magnoflow™ I noticed a slight increase in fuel consumption. How can you explain this?

A. This clearly shows that the Magnoflow™ is doing its job, by burning off the local coal deposits in the combustion area and the path to the combustion area, however this consumption is only temporary and will finally level off after the stabilization is complete.

Q. My vehicle knocks and pings. Will the Magnoflow™ keep my vehicle from knocking and pinging?

A. If you are currently having a problem with your vehicle knocking and pinging, then your vehicle should be repaired before installing your Magnoflow™. Your Magnoflow™ was not designed to repair vehicles.

Q. Can I use my “on-board” computer to compute my miles per gallon?

A. No, unfortunately it will not be accurate. Even those computers that you can “zero out” still use a greater than total miles driven and total fuel which skews the mileage. Drivers should manually record mileage based on actual odometer reading and gallons used at the gas station.

Q. Will it work on fuels other than unleaded gas?

A. Yes, it will work on diesel, but the percentage of improvement will differ from one type to the other.

Q. How does the Magnoflow™ clean the engine?

Your Engine builds up carbon/varnish deposits of incomplete combustion (improper burning).
Molecules are isolated and are found in both gas and diesel fuel. As the molecules begin to cluster and grow, some molecules become trapped during combustion, air is unable to reach the trapped molecules and they do not burn completely. Instead they are expelled into the atmosphere or retained as carbon/varnish deposits inside your engine. As these molecules pass through the Magnoflow™ it will break the cluster of molecules apart and stir them up, which otherwise could not penetrate the molecules. Magnoflow™ is now able to reach the individual molecules and complete combustion takes place.

Q. Where do I install Magnoflow™ on a diesel engine?

A. Just before the injector pump.

Q. Is the Magnoflow™ just a magnet?

A. No, it is not a regular magnet; it is a MATCHED PAIR of tuned custom sealed inductors that generate a frequency resonance between its two faces.

Q. Is it true that Magnoflow™ increases engine performance?

A. Yes Magnoflow™ increases engine performance by 8% and it is important that the driver should not change his/her driving habit, as the engine is more elastic, at the same time the acceleration behaviour is better. But if you keep using this surplus of power for faster starts, you will have no saving.

Q. What happens to fuel when I turn the motor off?

A. Because the fracturing of hydrocarbon chains occurs only when the fuel is passed through the Magnoflow™. When the engine is turned off, the fracturing of hydrocarbon chains stops and in matter of hours the condition of the fuel returns to the more congested state. The phenomena of fracturing the hydrocarbon chains only can be induced by the Magnoflow™.

Q. Does the Magnoflow™ need special care, as in the engine compartment there can be moisture?

A. NO. There is no special care needed, as the casing is made from a very high resistant material and the built in magnets can not rust due to their specific composition. To clean the device simply use washing detergent, NO chemicals.

Q. Can I use the Magnoflow™ in my new car if I sell the old one?

A. YES. You simply have to disengage Magnoflow™ from your old vehicle and install it in your new vehicle with a set of new cable fasteners.(extra cable fasteners are also supplied ) So you will take with you all the benefits of the Magnoflow™.