.

 Click for Installation Guides
INSTALLATION : Our Optimizer V3.2 works on all different type of coil designs for Petrol Driven Vehicles

CLICK : See More about Different Types Of IGNITION COIL Designs

Once you install it 1st time, the next is easy (for similar car model, engine)

 SINGLE COIL SYSTEM BUILT-IN COIL SYSTEM

Various types of cars installed...
Saloon, Hatchback, MPV, SUV,
Luxurious, etc

 animation to make the page more "alive"

 with SCREW LOCKING
 with CONNECTOR
 		 1 COIL
 1 COIL-HONDA CIVIC

1.5 N-VTEC
MULTI-COILS SYSTEM
 2 COILS
 3 COILS
 4 COILS
 4 COILS (DIS)
Direct Ignition System
(Distributorless)

INSTALLATION PROCEDURE
A.  CONFIRMATION OF  +12V  SUPPLY  WIRE
 1.  Unplug connector (or unscrew) from the coil.
2.  Switch on ignition key without starting engine.
3.  Use meter to confirm the +12V supply
     - Usually the wire diameter is thicker.
4.  After confirming the +12V supply wires, mark the wires.
5.  Use meter to check all the +12V wires and confirm that they are from the same point by using the meter diode range; cross check all the wires. The meter reading should be '000'.
     - Switch off the Ignition.
     - Note : If any of the wires is with readings, then the wire is not from the same point,
                 the installation should be done with One OPTIMIZER to One Coil.
B.  INSTALLATION  OF  OPTIMIZER V3.2 TO THE  IGNITION COIL  SYSTEM
6.  Cut the +12V supply wire.
7.  Remove the wire insulation, approximately 10 mm.
8.  Connect the Optimizer wire (RED) to the +12V supply  wire; and (BLUE) to the ignition coil.
9.  Connect the Optimizer ground wire (BLACK) to the car chassis or engine block.
     - Ensure proper grounding. Meter reading at diode range should be less than 5.
     - Proper GROUNDING will provide Optimum Performance.
C.  PLACEMENT  OF  OPTIMIZER  UNIT
10.  Place the Optimizer unit at any convenient location away from the engine body.
      - Avoid any of the wire from the Optimizer touching or crossing the high tension wire to the spark wire or distributor.
      - Secure the Optimizer wires with cable tie.

 

Tools you may need to install the optimizer...Common Tools
Test Pen - with built-in bulb

Crimper

Quick Connectors (supplied)

Multimeter

  

Shrinkable Tubings (supplied)
Cable Ties (supplied)

Note : You may prefer to use
strong Double Sided Tape
to hold the unit.

 
Back To Top

installation for VARIOUS IGNITION COIL DESIGNs
1. SINGLE Coil 2.  BUILT-IN Coil 3.  MULTI-Coils (2 Coils
- 4 Cylinders)		 4. MULTI-Coils (3 Coils
- 6 Cylinders)		 5. MULTI-Coils (4 Coils
- 4 Cylinders)		 6. MULTI-Coils (6 Coils
- 6 Cylinders)
  original no cutting wire

 click for bigger image

Installation Note : If in doubt - ASK!! Installation to be done by AUTHOURISED Installer